Впиши се, за да следиш темата  
Последователи 0
AtanasIvanov

Поправка на bios hp dv6-2120eq

12 мнения в тази тема

Здравейте колеги! Имам едно лаптопче с повреден биос и немога да намеря биос за програматор на гореспоменатия модел.Някой знае ли дали има някакъв друг начин за инсталиране на биос.Иначе индикациите са следните:
http://vbox7.com/play:500ce866bb

Share this post


Link to post
Share on other sites

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01443366&lc=en&dlc=en&cc=uk&lang=en&rule=26781&product=3816592

aps Lock/Num Lock LED Component Tested Error Condition LEDs blink 1 time CPU CPU not functional LEDs blink 2 times BIOS BIOS corruption failure LEDs blink 3 times Memory Module error not functional LEDs blink 4 times Graphics Graphics controller not functional LEDs blink 5 times System board General system board failure LEDs blink 6 times BIOS BIOS authentication failure

Share this post


Link to post
Share on other sites

и аз имам съмнения за южен мост ,но исках да пробвам и биоса.Има ли някакъв вариант и да е от биоса

Share this post


Link to post
Share on other sites

Биос може да си дръпнеш от официалния сайт на HP.Ама и на мен не ми се вярва да е от него.

Edited by maximalcho

Share this post


Link to post
Share on other sites

Имаше комбинация за "флашване на тъмно", без програматор лично аз съм го правил само ведъж....ще ти потърся командите, а не можеш ли да разкомпресираш екзетои да си вземеш бинчето ?

Share this post


Link to post
Share on other sites

Мерси колеги.. д-р Хаус ,ако можеш да ми помогнеш за флаша на тъмно без програматор ,ще съм ти много задължен

Share this post


Link to post
Share on other sites

Намерих ги,

Два файла трябва да са на празна флашка

Disconnect the AC adapter from the notebook.

Remove the battery from the notebook.

Insert the USB thumb drive in the slot closest to you.

Hold down and continue to hold the <Windows> Key and the <B> key.

Connect the AC adapter.

Press the 'Power' button on the notebook.

When the LEDs come on, let go of power button and the two keys held down earlier.


The touch pad LED may come on as amber (disabled) instead of the normal white (enabled).

After about 10 seconds the notebook should start reading the USB thumb drive.
While searching for the file the notebook beeped once a second.
The number of beeps varied, depending on how big the thumb drive was and
the number of files on the thumb drive, from just one beep to many.
If the file was not found, the notebook would reset itself and try again.

If the file was found then it took about 12 seconds for the notebook to load it.
No beeping sounds heard during the loading time.

When loaded the notebook started flashing, indicated by beeps every 2 seconds.
This took about 32 seconds.

About 5 seconds after the beeping had stopped the notebook shutdown.
BIOS worked normally thereafter.
Instructions from HERE

1 person likes this

Share this post


Link to post
Share on other sites

Май да, имам спомен че и аз го преименувах :)

Успех, стискам ти палци и да напишеш дали е станало

Share this post


Link to post
Share on other sites
Гост
You are commenting as a guest. If you have an account, please sign in.
Отговори на тази тема...

×   You have pasted content with formatting.   Remove formatting

×   Your link has been automatically embedded.   Display as a link instead

Loading...
Впиши се, за да следиш темата  
Последователи 0